There are many ways to operate the gasoline grinder, which will be shared with the Yamaha grinder manufacturer below.

(1) Before starting the machine, you must first open the gasoline engine winch transmission clutch, and turn the front and rear shift levers to the neutral position, and then start the machine.

(2) When turning the grinding clutch of the gasoline engine, the action should be fast, otherwise the interlock brake will not work, which will increase the impact force of the automatic brake pawl. It is not advisable to use too much force when starting the gasoline cutter, until the pulley can drive the input shaft to rotate without slipping.

(3) The transmission clutch of the gasoline winch must be opened when shifting gears, otherwise, the gears will be damaged.

(4) During the shifting process of the gasoline motorized grinder, if it is difficult to enter the gear, it cannot be forced into the gear, and the hand crank device can be used to help the gear. It rotates an angle to enter the block.

Diesel winch mill manufacturers teach you how to install wire ropes in gasoline engine motorized winch mills:

(1) Open the reel clutch, wrap the wire rope end on the reel to tighten, and then close the clutch.

(2) Disassemble the bearing support movable seat at the outer end of the reel, and wind the wire rope into the reel to tighten.

(3) Winding method of wire rope: from bottom to top, that is, the incoming rope is at the bottom, facing the reel, and winding counterclockwise. Brakes don't work.